Structural characterization and ferromagnetic behavior of Fe-doped TiO2 powder by high-energy ball milling

Fe-doped TiO₂ powder was prepared by high-energy ball milling, using TiO₂ Degussa P-25 and α-Fe powders as the starting materials. The structure and magnetic properties of the Fe-doped TiO₂ powder were studied by X-ray diffraction, ⁵⁷Fe Mossbauer spectroscopy and vibrating sample magnetometer. The Reitveld refinement of XRD revealed that ball milling not only triggered incorporation of Fe in TiO₂ lattice but also induced the phase transformation from anatase to rutile in TiO₂ and consequently the milled Fe-doped TiO₂ powder contained only rutile.⁵⁷Fe Mössbauer effect measure showed that Fe atoms existed in Fe²⁺ and Fe³⁺ state, which were assigned to the solid solution Fe_xTi_1−xO₂. The magnetization measurements indicated that the milled Fe-doped TiO₂ powder was ferromagnetic above room temperature. The ferromagnetism in our milled Fe-doped TiO₂ powder seemingly does not come from Fe and iron oxides particles/clusters but from the Fe-doped TiO₂ powder matrices.     

Multiband Terahertz Photonic Band Gaps of Subwavelength Planar Fractals

Optical transmission properties of subwavelength planar fractals in terahertz （THz） frequency regime are studied by means of time-domain spectroscopy. The transmission spectra with multiple pass bands and stop bands are observed. The tunable photonic band gaps are realized by changing the angle between the principle axis of planar fractal and the polarization of THz wave. The possible application of the subwavelength optical component is discussed. We attribute the detected transmittance from subwavelength fractals to localized resonances.     

500.8 nmNd∶YAG青光激光器光学薄膜的设计与制备

从双波长激光运转及和频的机理出发，对LD泵浦Nd∶YAG，LBO腔内和频500.8 nm〖JP2〗青光激光器所使用的光学薄膜进行了设计和制备.在激光反射镜的设计上，为了达到最佳的和频输出，对膜系要求进行了深入分析.采用对谐振腔一端面反射率固定不变并通过对另一腔镜基频光的透射率进行调谐的方法, 在给出合理初始结构后，利用计算机对膜厚进行了优化.并采用双离子束溅射沉积的方法，通过时间监控膜厚法成功制备出青光激光器所使用的全介质激光反射膜, 在室温下实现946 nm和1064 nm双波长连续运转，并通过Ⅰ类临界相位匹配LBO晶体腔内和频在国内首次实现500.8 nm青色激光连续输出.当泵浦注入功率为1.4 W时和频青光最大输出达20 mW.     

关于由衍射片的背面反射光形成的衍射图样的讨论

在光的衍射实验中,我们看到的一般是由通过衍射片的直射光形成的衍射图样,但在衍射片的另一面,同样存在着另一个衍射图样,它是由衍射片的背面反射光形成的,两个衍射图样关于衍射片对称.本文给出了这种实验现象,并用巴比涅原理解释了这种现象.     

SHS等离子喷涂制备FeAl2O4-Al2O3-Fe纳米复合涂层的研究

利用SHS等离子喷涂技术,将经过机械团聚法制备的Fe2O3-Al复合粉体送入等离子焰流,沉积出厚度约为400 μm的复合涂层.利用XRD,SEM 和TEM等检测手段对涂层的成分和组织进行了分析,测定了涂层的显微硬度、断裂韧性以及耐磨性.结果表明涂层为具有纳米结构的FeAl2O4-Al2O3-Fe纳米复合组织;涂层的显微硬度为HV100g870;断裂韧性是普通Al2O3涂层的2倍;无润滑磨损的耐磨性是普通Al2O3涂层的2.5倍.     

磁场对四端量子波导中电子输运性质的影响

采用模匹配方法，研究了非均匀磁场下开放的四端量子波导中的电子输运性质. 结果表明，从一端入射的电子可以透射到两个与之垂直的输出端和一个与之平行的输出端. 在没有外加磁场的情况下，两个垂直输出端的输运概率是相同的，但垂直端与水平端的输运概率不同；在外加磁场下，由于磁边缘态效应，两个垂直输出端的输运概率也有着相当大的差别. 通过施加不同的磁场，我们能获得丰富的电子输运结构，如台阶，宽谷，尖峰等；通过调节磁场的大小和比例以及结构参数可控制该量子结构在各输出端的输运概率. 关键词： 电子输运 介观体系 磁效应     

Mn替代对Dy2AlFe16-xMnx化合物的结构和磁性的影响

通过X射线衍射及磁测量手段研究了Dy2AlFe16-xMnx化合物的结构和磁性.研究结果表明Dy2AlFe16-xMnx化合物具有六角相的Th2Ni17型结构.对x=1,2的样品采用X射线热膨胀测定法在104-647K的温度范围内测量了其热膨胀性质,发现这些化合物在低温下存在热膨胀反常现象,在居里点附近出现负膨胀性质.对自发磁致伸缩的研究结果表明Dy2AlFe16-xMnx化合物中存在着较强的各向异性的自发磁致伸缩,随着Mn含量的增加,其低温下的自发体磁致伸缩减弱.磁测量结果表明Mn的替代导致Dy2AlFe16-xMnx化合物的居里温度及自发磁化强度急剧下降.     

Crystal field analysis of the magnetization curves of R2Fe17 and R2Fe17H3 (R=Tb,Ho,Er)

In this paper the values of the crystalline-electric-field parameters A_nm for R₂Fe₁₇ and R₂Fe₁₇H₃ (R=Tb,Ho,Er) are evaluated by fitting calculations to the magnetization curves measured on the single crystal at several temperatures. The fitted A_nm for R₂Fe₁₇ are strikingly different from those for the corresponding R₂Fe₁₇H₃. The energy gaps between the lowest four energy levels for Ho ions in Ho₂Fe₁₇₂ can be reproduced by using the fitted A_nm and exchange field 2μ_BH_ex, which estimated from the fit of the temperature dependence of the spontaneous magnetization combined with inelastic neutron scattering experiment.     

万用表检测电容器方法分析及改进

本文从教学实验的实践出发,对使用万用表测量电容器容量的方法进行了分析,并对电路进行了一定改进。     

超短脉冲激光光束在一维反射型体全息光栅中的衍射

基于Kogelnik的耦合波理论,研究了在色散效应的影响下,超短脉冲激光光束在反射型体全息光栅中衍射的性质.研究给出了衍射光及透射光在频谱域及时间域的振幅及强度分布、光栅的光谱宽度及衍射效率随光栅参量及入射条件的变化.数值研究的结果表明,在光栅记录介质色散效应的影响下,衍射光束的光谱宽度减小,脉冲展宽,衍射效率降低.通过适当的选取光栅参量及入射条件,可以控制衍射和透射光束的频谱和时间强度分布,得到满意的衍射和透射光束的带宽和波形,从而可以将其应用于脉冲整形等技术中.